Refer to “front brake caliper removal and installation” .
Note the right and left calipers are installed symmetrically and therefore the disassembly procedure for one side is the same as that for the other side. |
Disassembly
Caution do not use high pressure air to prevent piston damage. |
Assembly
Assemble the caliper in the reverse order of disassembly. Pay attention to the following points:
Bf: brake fluid (dot 4)
Caution
|
Caution replace the piston seals (1) and dust seals (2) with new ones. |
Bf: brake fluid (dot 4)
|
Steering / steering damper removal and
installation
Removal
steering damper
Turn the ignition switch off.
Disconnect the steering damper solenoid coupler
(1).
Remove the lower bracket cover (2).
Remove the steering damper mounting nut (3) while
holding the lock-nut (4).
Remove the steering damper mounting bolt ( ...
Excva adjustment
Inspect the excva operation and adjust it if necessary
in the following steps:
Step 1
Set the excva to the adjustment position. Refer to
“excv cable removal and installation” (page 1k-
6).
Step 2
Turn the ignition switch off.
Turn the mode select switch off.
Turn the ...
Fuel tank removal and installation
Removal
Keep away from fire or spark.
Spilled gasoline should be wiped off
immediately.
Work in a well-ventilated area.
Remove the front seat. Refer to “exterior parts
removal and installation” in section 9d (page 9d-
6).
Take ...