Note the right and left calipers are installed symmetrically and therefore the removal procedure for one side is the same as that for the other side. |
Removal
Note place a rag underneath the union bolt on the brake caliper to catch any spilt brake fluid. |
Installation
Install the brake caliper in the reverse order of removal.
Pay attention to the following points:
Tightening torque front brake caliper mounting bolt (a): 39 n·m (3.9 Kgf-m, 28.0 Lbf-ft)
Caution the seal washers should be replaced with the new ones to prevent fluid leakage. |
Tightening torque brake hose union bolt (b): 23 n·m (2.3 Kgf-m, 16.5 Lbf-ft)
Brake fluid, if it
Check the brake hose and hose joints for cracks and fluid leakage. |
Front seat
To remove the front seat.
Remove the bolts 1 (right and
left).
Raise the front end of the seat
and slide it forward.
To reinstall the seat, slide the seat
hooks into the seat hook retainers
on the frame and tighten the bolts
securely.
Warning
Failure to insta ...
Excva adjustment
Inspect the excva operation and adjust it if necessary
in the following steps:
Step 1
Set the excva to the adjustment position. Refer to
“excv cable removal and installation” (page 1k-
6).
Step 2
Turn the ignition switch off.
Turn the mode select switch off.
Turn the ...
Electrical parts connector / coupler
Faulty fi system is often related to poor electrical
contact of connector/coupler. Before servicing
individual electronic part, check electrical contact of
the connector/coupler.
When connecting a connector, be sure to push it in
until a click is felt.
With a lock type coupler ...