Brake disc thickness
Check the brake disc for damage or cracks and measure the thickness using the micrometer.
Replace the brake disc if the thickness is less than the service limit or if defect is found.
Special tool
(a): 09900–20205 (micrometer (0 –
25 mm))
Brake disc thickness service limit (front): 5.0 Mm (0.20 In)
Brake disc runout
Replace the disc if the runout exceeds the service limit.
Special tool
(a): 09900–20607 (dial gauge)
: 09900–20701 (dial gauge chuck)
Brake disc runout service limit: 0.30 Mm (0.012 In)
Exterior parts removal and installation
Side frame cover
Removal
Note
the left and right side frame covers are
installed symmetrically and therefore the
removal/installation procedure for one side is
the same as that for the other side.
Remove the bolt (1).
Remove the side frame cover (2).
...
Starter torque limiter removal and
installation
Removal
Remove the clutch assembly. Refer to “clutch removal” in section 5c .
Remove the washer (1), starter idle gear no. 1 (2)
And starter torque limiter (3).
Installation
Installation is in the reverse order of removal. Pay
attention to the following point:
apply ...
Throttle body removal and installation
Removal
Remove the side cowlings. Refer to “exterior parts
removal and installation” in section 9d (page 9d-
6).
Remove the air cleaner box. Refer to “air cleaner box removal and
installation” .
Remove the clamps (1).
Disconnect the iap sensor (2) from the vacuum
...