Suzuki GSX-R 1000 Service Manual: Front brake hose routing diagram

Suzuki GSX-R 1000 Service Manual / Brake / Brake control system and diagnosis / Schematic and routing diagram / Front brake hose routing diagram

Suzuki GSX-R. Front brake hose routing diagram

Hose clamp
: clamp end should face downward.
Stopper
: after the brake hose union has contacted to the stopper, tighten the union bolt.
Hose guide : pass the brake hose through the hose guide.
Stopper
: after positioning the clamp with the stopper, tighten the clamp bolt.
Hose clamp
: insert the clamp end into the hole on the front fender.
White marking
: white marking should be on right side and face upward.
Clamp the
brake hose firmly.
Pass the
brake hose through rear side of the throttle cables.
23 N·m (2.3 Kgf-m,
16.5 Lbf-ft)

Schematic and routing diagram

...

Rear brake hose routing diagram

Hose clamp : face the clamp end backward. Stopper : after the brake hose union has contacted to the stopper, tighten the union bolt. Brake pad pin Plug ...

Other materials:

Loading guidelines
This motorcycle is primarily intended to carry small items when you are not riding with a passenger. Follow the guidelines below to carry a passenger or cargo: balance the load between the left and right side of the motorcycle and fasten it securely. Place cargo weight as ...

Excva pulley inspection
Inspect the excva pulley in the following procedures: remove the excva pulley. Refer to “excv cable removal and installation” . Visually inspect the excva pulley for wear and damage. If there is anything unusual, replace the pulley with a new one. Install the pulle ...

Engine coolant temperature indicator light inspection
Inspect the engine coolant temperature meter and indicator light (led) in the following procedures: remove the left side cowling. Refer to “exterior parts removal and installation” in section 9d . Disconnect the ect sensor coupler (1). Connect a variable resistor (2) ...