Suzuki GSX-R 1000 Service Manual: Front brake light switch inspection
Inspect the front brake light switch in the following procedures:
- disconnect the front brake light switch coupler (1).
- Inspect the front brake light switch for continuity with
the tester.
If any abnormality is found, replace the front brake light switch with a new one. Refer to “front brake master cylinder / brake lever disassembly and assembly” .
Special tool
: 09900–25008 (multi circuit
tester set)
Tester knob indication
continuity (
)
- Connect the front brake light switch coupler.
Repair instructions
Brake pedal height inspection and
adjustment
Refer to “brake system inspection” in section 0b . ...
Rear brake light switch inspection
Inspect the rear brake light switch in the following
procedures:
lift and support the fuel tank. Refer to “fuel tank
removal and installation” in section 1g (page 1g-
9).
Discon ...
Other materials:
Fuel
Your motorcycle requires premium
unleaded gasoline with a
minimum pump octane rating of
90 ((r+m)/2 method). In some
areas, the only fuels that are
available are oxygenated fuels.
Oxygenated fuels which meet the
minimum octane requirement and
the requirements described below
may be used i ...
Charging system symptom diagnosis
Condition
Possible cause
Correction / reference item
Generator does not
charge
Open- or short-circuited lead wires, or
loose lead connections.
Repair, replace or connect properly.
Short-circuited, grounded or open
generator coil.
Replace
...
Valve seat repair
The valve seats (1) for both the intake and exhaust
valves are machined to three different angles. The seat
contact surface is cut at 45°.
Intake valve
Exhaust valve
Caution
the valve seat contact area must be
inspected after e ...