Refer to “front fork disassembly and assembly” .
Inner and outer tubes
Inspect the inner tube and outer tube for scratches
Slide bushing / guide bushing
Inspect the slide bushing and guide bushing for wear or damage. If they are worn or damaged, replace them with new ones. If they are not clean, clean them with a nylon brush and fork oil.
Fork spring
Measure the fork spring free length “a”. If it is shorter than the service limit, replace it with a new one.
Front fork spring free length “a” service limit: 236 mm (9.29 In)
Piston rod / piston ring
Inspect the piston rod and piston ring (1) for wear or damage. If any defects are found, replace the piston rod with a new one
Storage procedure
If your motorcycle is to be left
unused for an extended period of
time, it needs special servicing
requiring appropriate materials,
equipment and skill. For this reason,
suzuki recommends that you
trust this maintenance work to
your suzuki dealer. If you wish to
service the machine for stora ...
Dtc “c36” (p1764), “c37” (p1765), “c38” (p1766) or “c39” (p1767): secondary
fuel injector circuit
malfunction
Detected condition and possible cause
Detected condition
Possible cause
Some failure exists in the fuel injector signal in a high
load, high revolution condition.
Injector circuit open or short.
Injector malfunction.
Ecm malfunction.
...
Inspecting the drive chain
When inspecting the chain, look
for the following:
loose pins
damaged rollers
dry or rusted links
kinked or binding links
excessive wear
improper chain adjustment
If you find anything wrong with the
drive chain condition or adjustment,
correct the pr ...