After installing the front fork, adjust the spring pre-load and two kinds of damping force as follows:
Adjust the
left and right front forks to the same setting. |
Spring pre-load adjustment
Turn the spring pre-load adjuster (1) counterclockwise fully. From that position (softest), turn it clockwise to the specified position.
Std position 4 turns in from softest position
Damping force adjustment
Rebound damping force
Fully turn the rebound damping force adjuster (1) clockwise. From that position (stiffest), turn it out to standard setting position.
Std position 4 turns out from stiffest position
Compression damping force
Fully turn the compression damping force adjuster (1) clockwise. From that position (stiffest), turn it out to standard setting position.
Std position 5 turns from stiffest position
Throtile cable play
This motorcycle has a twin throttle
cable system. Cable A is for pulling
cable and cable B is for
returning.
To adjust the cable play:
Loosen the lock nut 1.
Turn the adjuster 2 so that the
throttle grip has 2.0 - 4.0 Mm
(0.08- 0.16 In) play.Tighten the lock nut 1.
...
Rear turn signal light bulb replacement
Caution
when you touch the bulb with your bare
hands, clean the bulb with a cloth moistened
with alcohol or soap water to prevent
premature bulb failure.
Remove the rear turn signal light lens (1).
Replace the bulb (2).
Reinstall the removed parts
...
Specifications
Service data
Oil pump
Oil
Tightening torque specifications
Reference: for the tightening torque of fastener not specified in this
section, refer to “tightening torque list” in section 0c . ...