Removal
Caution do not operate the brake lever with the caliper removed. |
Caution do not carry out the work with the motorcycle resting on the side-stand. Do not support the motorcycle with the exhaust pipes. Make sure that the motorcycle is supported securely. |
Note after removing the front wheel, fit the calipers temporarily to the original positions. |
Installation
The directional
|
Tightening torque front brake caliper mounting bolt (a): 39 n·m ( 3.9 Kgf-m, 28.0 Lbf-ft)
After remounting
|
Special tool
(a): 09900–18740 (hexagon socket
(24
mm))
Tightening torque front axle bolt (b): 100 n·m (10.0 Kgf-m, 72.5 Lbfft)
Tightening torque front axle pinch bolt (c): 23 n·m (2.3 Kgf-m, 16.5 Lbf-ft)
Tightening torque front axle pinch bolt (d): 23 n·m (2.3 Kgf-m, 16.5 Lbf-ft)
Ap sensor removal and installation
Removal
Remove the front seat. Refer to “exterior parts
removal and installation” in section 9d (page 9d-
6).
Disconnect the starter relay (1) from the holder.
Disconnect the coupler (2) and remove the ap
sensor (3).
Installation
Install the ap sensor in the rever ...
Cam chain guide / cam chain tensioner
removal and installation
Removal
Remove the cylinder head cover. Refer to “engine top side disassembly” .
Remove the cam chain guide no. 2 (1).
Remove the cylinder head. Refer to “engine top side disassembly”
and “engine bottom side disassembly” .
Remove the starter clutch. Refer to “s ...
DTC “c49” (p1656): pair control solenoid
valve circuit malfunction
Detected condition and possible cause
Detected condition
Possible cause
Pair control solenoid valve voltage is not input to ecm
Pair control solenoid valve circuit open or short.
Pair control solenoid valve malfunction.
Ecm malfunction.
...