Suzuki GSX-R 1000 Service Manual: Front wheel dust seal / bearing removal and installation
Removal
- Remove the front wheel assembly. Refer to “front wheel assembly removal and installation” .
- Remove the dust seals using the special tool.
Special tool
(a): 09913–50121 (oil
seal remover)
- Remove the wheel bearings using the special tool.
Special tool
(b): 09921–20240 (bearing remover
set)
- Remove the spacer (1).
Installation
| Caution the removed dust seals and bearings must be replaced with new ones. |
- Apply grease to the wheel bearings.
: Grease 99000–25010 (suzuki
super
grease “a” or equivalent)
- First install the right wheel bearing, then install the spacer (1) and left wheel bearing with the special tool.
Special tool
(a):
09924–84510 (bearing installer set)
(b):
09941–34513 (bearing installer)
| Caution the sealed cover of the bearing must face outside. |
|
- Install the dust seals with the special tool.
Special tool
(c):
09913–70210 (bearing installing set (10
– 75 Ô))
- Apply grease to the lip of dust seals.
: Grease 99000–25010 (suzuki
super
grease “a” or equivalent)
- Install the front wheel assembly. Refer to“front wheel assembly removal and installation” .
Front wheel related parts inspection
Refer to “front wheel assembly removal and installation” .
Tire
Refer to “tire inspection” in section 0b .
Front brake disc
Refer to “front brake disc inspection” in section 4b .
Dust seal
...
Rear wheel components
Rear axel nut
Collar
Dust seal
Bearing
Retainer
Rear sprocket
Sprocket mounting drum
Wheel damper
Bearing
Spacer
Air valve
Rear wheel
...
Other materials:
Tire inspection
Inspect tire
every 6 000 km (4 000 miles, 12 months)
Tire tread condition
Operating the motorcycle with excessively worn tires will
decrease riding stability and consequently invite a
dangerous situation. It is highly recommended to replace
a tire when the remaining depth of tire tread reaches ...
Special tools and equipment
Recommended service material
Note
required service material is also described in the following.
“Transmission components” “gearshift lever construction”
“gearshift shaft / gearshift cam plate components” “gearshift
shaft construction”
Special to ...
DTC “c49” (p1656): pair control solenoid
valve circuit malfunction
Detected condition and possible cause
Detected condition
Possible cause
Pair control solenoid valve voltage is not input to ecm
Pair control solenoid valve circuit open or short.
Pair control solenoid valve malfunction.
Ecm malfunction.
...