Refer to “front wheel assembly removal and installation” .
Tire
Refer to “tire inspection” in section 0b .
Front brake disc
Refer to “front brake disc inspection” in section 4b .
Dust seal
Inspect the lip of dust seals for wear or damage. If any defects are found, replace the dust seal with a new one.
Refer to “front wheel dust seal / bearing removal and installation” .
Wheel axle
Using a dial gauge, check the wheel axle for runout. If the runout exceeds the limit, replace the axle shaft.
Special tool (a): 09900–20607 (dial gauge) (b): 09900–20701 (dial gauge chuck) (c): 09900–21304 (v blocks)
Wheel axle runout service limit: 0.25 Mm (0.010 In)
Wheel
Wheel rim runout service limit (axial and radial): 2.0 Mm (0.08 In)
Wheel bearing
Inspect the play of the wheel bearings by finger while they are in the wheel. Rotate the inner race by finger to inspect for abnormal noise and smooth rotation. Replace the bearing if there is anything unusual. Refer to “front wheel dust seal / bearing removal and installation” .
Front fork removal and installation
Note
the right and left front forks are installed
symmetrically and therefore the removal
procedure for one side is the same as that for
the other side.
Removal
Remove the front wheel. Refer to “front wheel assembly removal and
installation” in section 2d .
...
Tire removal and installation
Removal
The most critical factor of a tubeless tire is the seal
between the wheel rim and the tire bead. For this
reason, it is recommended to use a tire changer that can
satisfy this sealing requirement and can make the
operation efficient as well as functional.
Removal the wheel ass ...
Transmission components
2Nd drive gear
6Th drive gear
3Rd/4th drive gear
5Th drive gear
Countershaft/1st drive gear
Driveshaft
2Nd driven gear
6Th driven gear
3Rd driven gear
4Th driven gear
5Th driven gear
1St driven gear
Gearshift cam stopper
Gearshi ...