Suzuki GSX-R 1000 Owners Manual: Front wheel removal
- Place the motorcycle on the side stand.
- Remove both brake calipers from the front forks by removing two mounting bolts 1 on each calipers.
Note
: never squeeze the front brake lever with the caliper removed. It is very difficult to force the pads back into the caliper assembly and brake fluid leakage may result.
- Remove the bolts 2.
- Loosen the axle holder bolts 3.
- Loosen the axle holder bolts 4.
- Place an accessory service stand or equivalent under the swing arm to help stabilize the rear end.
- Carefully position a jack under the exhaust pipe and raise until the front wheel is slightly off the ground.
|
Caution Improper jacking may cause damage to the fairing or oil filter. Do not apply the jack head to the fairing lower part or the oil filter when jacking up the motorcycle. |
- Draw out the axle shaft.
- Slide the front wheel forward.
- To reinstall the wheel assembly, reverse the sequence as described.
- Hold the shaft and tighten the bolt 5 to the specified torque.
- Tighten the axle holder bolts 6 to the specified torque.
- Move the steering up and down several times.
- Tighten the axle holder bolts 7 To the specified torque.
- After installing the wheel, apply the brake several times to restore the proper lever stroke.
 Warning
Before riding, "pump" the brake repeatedly until brake pads are pressed against the brake disks and proper lever/ pedal stroke and firm feel are restored. Also check that the wheel rotates freely. |
| Warning
The tire for this motorcycle is directional. Therefore, the motorcycle may have unusual handling if the wheel is installed incorrectly. Install the front wheel in a specified direction, as indicated by the arrow on the sidewall of the tire. |
| Warning
Torque bolts and nuts to the proper specifications. If you are not sure of the proper procedure, have your authorized suzuki dealer or qualified mechanic do this. |
Front axle tightening torque: 100 n·m (1 0.0 Kgf-m, 72.5 Lb-ft)
Front axle holder bolt tightening torque: 23 n·m (2.3 Kgf-m, 16.5 Lb-ft)
Front brake caliper mounting bolt tightening torque: 39 n·m (3.9 Kgf-m, 28.0 Lb-ft)
Side standngnition interlock switch
Check the side stand/ignition
interlock system for proper operation
as follows:
Sit on the motorcycle in the
normal riding position, with the
side stand up.
Shift into firs ...
Rear wheel removal
Place the motorcycle on the
side stand.
Remove the cotter pin 1.
Remove the axle nut 2.
Warning
A hot muffler can burn you.
The muffler will be hot enough
to ...
Other materials:
Diagnostic information and procedures
Drive chain and sprocket symptom diagnosis
Condition
Possible cause
Correction / reference item
Noisy drive chain
Worn sprocket
Replace
Worn drive chain
Replace
Stretched drive chain
Replace
Too large drive chain slack
Adju ...
Wheel balance check and adjustment
Check and adjust the wheel balance in the following
procedures:
removal the wheel assembly. Refer to “front wheel assembly removal and
installation” and “rear wheel assembly removal and installation” .
Remove the mounting drum from the rear wheel.
(For rear wheel) ref ...
Engine oil and filter change
Change the engine oil and oil filter
at the scheduled times. The
engine should always be warm
when the oil is changed so the oil
will drain easily. The procedure is
as follows:
Place the motorcycle on the
side stand.
Remove the three screws of
the right fairing 1.
...