Suzuki GSX-R 1000 Service Manual: Fuel discharge amount inspection
|
|
Inspect the fuel discharge amount in the following procedures:
- lift and support the fuel tank. Refer to “fuel tank removal and installation” .
- ) Place a rag under the fuel feed hose (1) and disconnect fuel feed hose from the fuel pump.
- Connect a proper fuel hose (2) to the fuel pump.
- Place the measuring cylinder and insert the fuel hose end into the measuring cylinder.
- Disconnect the fuel pump lead wire coupler (3).
- Connect a proper lead wire into the fuel pump lead
wire coupler (fuel pump side) and apply 12 v to the
fuel pump (between (+) y/r wire and (–) b/w wire)
for 10 seconds and measure the amount of fuel
discharged.
If the discharge amount is out of the specification, the probable cause may be failure of the fuel pump or clogged fuel filter.
| Note the battery must be in fully charged condition. |
Fuel discharge amount 222 ml (7.5/7.8 Us/lmp oz) and more/10 seconds
- After finishing the fuel discharge inspection, reinstall the fuel tank. Refer to “fuel tank removal and installation” .
| Note connect the fuel feed hose to the fuel pump until it locks securely (a click is heard). |
Fuel pump inspection
Turn the ignition switch on and check that the fuel pump
operates for a few seconds.
If the fuel pump motor does not make operating sound, inspect the fuel pump
circuit connections or inspect th ...
Fuel pump relay inspection
Refer to “electrical components location” in section 0a .
Inspect the fuel pump relay in the following procedures:
remove the frame covers. Refer to “exterior parts
removal and installa ...
Other materials:
DTC “c41” (p0230-h/l): fp relay circuit
malfunction
Detected condition and possible cause
Detected condition
Possible cause
C41
No voltage is applied to fuel pump.
Fuel pump relay circuit open or short.
Fuel pump relay malfunction.
Fuel pump relay switch circuit is shorted to power
source.
...
Special tools and equipment
Recommended service material
Note
required service material is also described in the following.
“Front brake master cylinder components” “rear brake master
cylinder components” “rear brake pedal construction”
Special tool
...
Engine components removable with the
engine in place
Engine components which can be removed while the engine is installed on the
frame are as follows. For the installing
and removing procedures, refer to respective paragraphs describing each
component.
Center of engine
Item
Removal
Inspection
Installation
...