Gsx-r1000 motorcycles are equipped with a fuel injection system for emission level control. This fuel injection system is precision designed, manufactured and adjusted to comply with the applicable emission limits. With varying engine conditions, all of the fuel injection volumes are precisely controlled by the programmed injection maps in the ecm to reduce co, nox and hc. Adjusting, interfering with, improper replacement, or resetting of any of the fuel injection components may adversely affect injection performance and cause the motorcycle to exceed the exhaust emission level limits.
|
Rear lighting system construction
License plate light assembly
Reflex reflector (e-03, 28, 33 only)
Clamp
: clamp the license plate light lead wire
so as not to be slack.
Rear combination light
Rear turn signal light assembly (lh/rh)
5
N·m (0.5 Kgf-m, 3.5 Lbf-ft)
1.8 N·m
...
Front brake caliper parts inspection
Refer to “front brake caliper disassembly and assembly” .
Brake caliper cylinder
Inspect the brake caliper cylinder wall for nicks,
scratches or other damage. If any damage is found,
replace the caliper with a new one.
Brake caliper piston
Inspect the surface of brake caliper pistons for a ...
Gearshift shaft / gearshift cam plate components
Gearshift shaft
Gearshift cam drive plate
Gearshift cam plate
Gearshift cam stopper
19 N·m (1.9 Kgf-m,
13.5 Lbf-ft)
13 N·m
(1.3 Kgf-m, 9.5 Lbf-ft)
8.5 N·m
(0.85 Kgf-m, 6.0 Lbf-ft)
Apply grease to oil
seal lip.
Apply thread l ...