Suzuki GSX-R 1000 Service Manual: Fuel injector inspection and cleaning
Inspect the fuel injector in the following procedures:
- remove the fuel injector. Refer to “throttle body disassembly and assembly” in section 1d .
- Check the fuel injector for evidence of dirt and contamination. If present, clean and check for presence of dirt in the fuel lines and fuel tank.
- Install the fuel injector. Refer to “throttle body disassembly and assembly” in section 1d .
Fuel mesh filter inspection and cleaning
Inspect the fuel mesh filter in the following procedures:
remove the fuel mesh filter. Refer to “fuel pump disassembly and
assembly” .
If the fuel mesh filter is clogged with fore ...
Specifications
Service data
Injector + fuel pump + fuel pressure regulator
Fuel
Tightening torque specifications
Note
the specified tightening torque is described in the following.
“Fuel ...
Other materials:
Ect sensor removal and installation
Removal
Remove the left side cowling. Refer to “exterior parts removal and
installation” in section 9d .
Drain engine coolant. Refer to “cooling system inspection” in section
0b .
Disconnect the coupler and remove the ect sensor
(1).
Caution
take special care ...
General description
Combination meter system description
This combination meter mainly consists of a stepping motor, lcd (liquid
crystal display) and leds (light emitting
diode).
The tachometer pointer is driven by the stepping motor.
The lcds indicate followings:
speed, odo / trip 1 / trip 2 / fuel reserve ...
Headlight beam adjustment
Adjust the headlight beam, both horizontally and
vertically.
Note
to adjust the headlight beam, adjust the
beam horizontally first, then vertically.
It is not necessary to remove the
combination meter to turn the adjusters.
Horiz ...