|
Inspect the fuel pressure in the following procedures:
Special tool
(a): 09940–40211 (fuel pressure
gauge
adapter)
(b): 09940–40220 (fuel pressure
gauge
attachment)
(c): 09915–77331 (oil pressure gauge
(1000
kpa))
(d): 09915–74521 (adapter hose)
Fuel pressure approx. 300 Kpa (3.0 Kgf/cm2, 43 psi)
If the fuel pressure is lower than the specification, check for the followings:
If the fuel pressure is higher than the specification, check for the followings:
Before
removing the special tools, turn the ignition switch off and release the fuel pressure slowly. |
Note connect the fuel feed hose to the fuel pump until it locks securely (a click is heard). |
Rear lighting system construction
License plate light assembly
Reflex reflector (e-03, 28, 33 only)
Clamp
: clamp the license plate light lead wire
so as not to be slack.
Rear combination light
Rear turn signal light assembly (lh/rh)
5
N·m (0.5 Kgf-m, 3.5 Lbf-ft)
1.8 N·m
...
Rear brake light switch inspection and adjustment
Check the rear brake light switch so that the brake light
will come on just before pressure is felt when the brake
pedal is depressed. If the brake light switch adjustment
is necessary, turn the adjuster nut (1) in or out while
holding the brake pedal.
Brake fluid level check
Refer to “bra ...
Most accidents can be avoided
The most common type of motorcycle
accident in the u.S. Occurs
when a car traveling towards a
motorcycle turns left in front of the
motorcycle. Is that because other
drivers are out to get motorcyclists?
No. Other drivers simply
don't always notice motorcyclists.
Ride defensively. Wise mot ...