Removal
Installation
Install the gear position switch in the reverse order of removal. Pay attention to the following points:
Caution replace the o-ring with a new one. |
Note align the gear position switch pin “a” with the gearshift cam hole “b”. |
: Grease 99000–25010 (suzuki
super
grease “a” or equivalent)
Tightening torque gear position switch mounting bolt (a): 6.5 N·m ( 0.65 Kgf-m, 4.5 Lbf-ft)
Noise emission control system description
Tampering with the noise control system prohibited: local law or federal law
prohibits the following
acts or the causing thereof:
the removal or rendering inoperative by any person, other than for
purposes of maintenance, repair or
replacement, of any device or element of design in ...
Precautions
Precautions for clutch system
Refer to “general precautions” in section 00 (page 00-1).
Schematic and routing diagram
Clutch cable routing diagram
Refer to “throttle cable routing diagram” in section 1d .
Diagnostic information and procedures
Clutch system symptom diagnosis
...
Rear brake hose routing diagram
Hose clamp
: face the clamp end backward.
Stopper
: after the brake hose union has contacted
to the stopper, tighten the union bolt.
Brake pad pin
Plug
Caliper sliding pin b
Caliper sliding pin a
White marking
Yellow marking
Pass the
...