This motorcycle has a 6-speed transmission which operates as shown. To shift properly, squeeze the clutch lever and close the throttle at the same time you operate the gearshift lever. Lift the gearshift lever to upshift and depress the lever to downshift.
Neutral is located between low and 2nd gear. When neutral is desired, depress or lift the lever halfway between low and 2nd gear.
Note
: when the transmission is in neutral, the green indicator light on the instrument panel will be lit.
However, even though the light is illuminated, cautiously release the clutch lever slowly to determine whether the transmission is positively in neutral.
Swingarm removal and installation
Removal
Cut the drive chain. Refer to “drive chain replacement” in section 3a .
Remove the rear wheel assembly. Refer to “rear wheel assembly removal
and installation” in section 2d .
Disconnect the rear brake hose from the brake hose
clamp (1).
Remove the brake ho ...
Front turn signal light bulb replacement
Caution
when you touch the bulb with your bare
hands, clean the bulb with a cloth moistened
with alcohol or soap water to prevent
premature bulb failure.
Remove the turn signal light assembly.
Remove the socket (1) by turning it
counterclockwise.
Repla ...
Cooling fan relay inspection
Inspect the fan relay in the following procedures:
remove the frame covers. Refer to “exterior parts
removal and installation” in section 9d (page 9d-
6).
Remove the cooling fan relay (1).
First check the insulation between “a” and “b”
terminals with tester. Then ap ...