Suzuki GSX-R 1000 Service Manual: Gearshift lever construction
|
28 N·m (2.8 Kgf-m,
40 N·m
Apply grease.
Grease.
Gear position (gp) switch removal and installation
Removal
Turn the ignition switch off.
Lift and support the fuel tank. Refer to “fuel tank
removal and installation” in section 1g (page 1g-
9).
Disconnect the gear position swi ...
Gearshift lever height inspection and
adjustment
Inspect and adjust the gearshift lever height in the
following procedures:
inspect the gearshift lever height “a” between the
lever top and footrest.
Adjust the gearshift lever height i ...
Other materials:
Short circuit check (wire harness to ground)
Disconnect the negative (–) cable from the battery.
Disconnect the connectors/couplers at both ends of
the circuit to be checked.
Note
if the circuit to be checked branches to other
parts as shown, disconnect all connectors/
couplers of those parts. Otherwise, diagnos ...
Clamp
Clamp the wire harness at such positions as indicated in “wiring harness
routing diagram” in section 9a .
Bend the clamp properly so that the wire harness is
clamped securely.
In clamping the wire harness, use care not to allow it
to hang down.
Do not use wire or an ...
General description
Engine coolant description
Caution
use a high quality ethylene glycol base
anti-freeze, mixed with distilled water. Do
not mix an alcohol base anti-freeze and
different brands of anti-freeze.
Do not put in more than 60% anti-freeze or
less than 50%. (Refer ...