Inspect and adjust the gearshift lever height in the following procedures:
Adjust the gearshift lever height if necessary.
Gearshift lever height “a” standard: 65 – 75 mm (2.6 – 3.0 In)
Show data when trouble (displaying data at
the time of DTC)
Use of sds
Ecm stores the engine and driving conditions (in the form of data as shown in
the figure) at the moment of the
detection of a malfunction in its memory. This data is called “show data when
trouble”.
Therefore, it is possible to know engine and driving conditions (e.G., Whether
...
Special tools and equipment
Recommended service material
Note
required service material is also described in the following.
“Rear lighting system construction”
Special tool
...
Rod guide case tightening torque
Tighten the rod guide case in the following procedures:
measure the effective length l of the torque wrench.
Calculate the reading torque on the torque wrench by
use of the formula shown below.
Special tool
(a): 09940–84710 (rod guide case
wrench)
T: reading torque on the torq ...