Suzuki GSX-R 1000 Service Manual: Gearshift linkage inspection
Refer to “gearshift shaft / gearshift cam plate removal and installation” .
Gearshift shaft
Check the gearshift shaft for bend or wear.
Check the return spring for damage or fatigue.
If any defects are found, replace the defective part(-s).
Gearshift shaft oil seal
Inspect the gearshift shaft oil seal lip for damage or wear. If any defect is found, replace the oil seal with a new one.
Gearshift shaft bearing
Inspect the gearshift shaft bearings for abnormal noise and smooth rotation. Replace the bearing if there is anything unusual.
Gearshift shaft / gearshift cam plate removal
and installation
Removal
Remove the engine sprocket cover. Refer to “engine sprocket removal and
installation” in section 3a .
Remove the clutch components. Refer to “clutch removal” in section 5c .
& ...
Gearshift shaft oil seal / bearing removal and installation
Removal
Remove the gearshift shaft. Refer to “gearshift shaft / gearshift cam
plate removal and installation” .
Remove the gearshift shaft oil seal (1).
Remove the bearings (2 ...
Other materials:
Specifications
Tightening torque specifications
Note
the specified tightening torque is described in the following.
“Chassis bolt and nut inspection”
Reference: for the tightening torque of fastener not specified in this
section, refer to “tightening torque list” in section 0c . ...
Accessory use
The addition of unsuitable accessories
can lead to unsafe operating
conditions. It is not possible
for suzuki to test each accessory
on the market or combinations of
all the available accessories; however,
your dealer can assist you in
selecting quality accessories and
installing them correc ...
Specifications
Service data
Fi sensors
Tightening torque specifications
Reference: for the tightening torque of fastener not specified in this
section, refer to “tightening torque list” in section 0c . ...