Suzuki GSX-R 1000 Service Manual: Gearshift shaft construction
|
8.5 N·m (0.85 Kgf-m,
13 N·m
19 N·m
Apply grease.
Apply thread lock to the
Apply thread lock to the
Apply engine oil to
Do not reuse.
Gearshift shaft / gearshift cam plate components
Gearshift shaft
Gearshift cam drive plate
Gearshift cam plate
Gearshift cam stopper
19 N·m (1.9 Kgf-m,
13.5 Lbf-ft)
13 N·m
(1.3 Kgf-m, 9.5 Lbf-ft)
...
Gearshift shaft / gearshift cam plate removal
and installation
Removal
Remove the engine sprocket cover. Refer to “engine sprocket removal and
installation” in section 3a .
Remove the clutch components. Refer to “clutch removal” in section 5c .
& ...
Other materials:
Excva removal and installation
Removal
Turn the ignition switch off.
Remove the left side cowling. Refer to “exterior parts removal and
installation” in section 9d .
Connect the special tool (mode select switch) to the dealer mode
coupler. Refer to “self-diagnostic procedures” in section 1a .
After tur ...
Batiery
The battery is located under the
front seat. Remove the front seat
by referring to the seat lock
and helmet holders section.
This battery is sealed type
and requires no maintenance.
Have your dealer check the battery's
state of charge periodically.
The standard charging rate is
1.2A x ...
DTC table
In the lcd (display) panel, the malfunction code is indicated from small code
to large code.
*1 To get the proper signal from the throttle position sensor, the sensor basic
position is indicated in the lcd
(display) panel. The malfunction code is indicated in three digits. In front o ...