Removal
Special tool
(a): 09921–20210 (bearing remover
(12
mm))
(b): 09930–30104 (rotor remover
sliding
shaft)
Installation
Install the oil seal and bearing in the reverse order of removal. Pay attention to the following points:
Caution the removed oil seal and bearings must be replaced with new ones. |
Note the stamped mark side of gearshift shaft bearing faces outside. |
Special tool
(a): 09913–70210 (bearing
installing set (10
– 75 Ô))
Special tool
(a): 09913–70210 (bearing
installing set (10
– 75 Ô))
: Grease 99000–25010 (suzuki
super
grease “a” or equivalent)
Front turn signal light removal and installation
Removal
Remove the screw.
Disconnect the front turn signal coupler (1).
Remove the turn signal light assembly (2).
Installation
Install the front turn signal light in the reverse order of
removal. ...
Fuses
The main fuse is located under
the front seat. To access the fuse,
remove the seat by referring to
the seat lock and helmet
holders.
The fuses are located inside the
left fairing. One 1 oa and one 15a
spare fuses are provided inside
the fuse box.
They are designed to open when ...
Swingarm related parts inspection
Refer to “swingarm removal and installation” (page 2c-
9).
Spacers
Remove the collar and spacer from the swingarm.
Inspect the collars and spacer for wear and damage.
If any defects are found, replace them with new
ones.
Chain buffer
Inspect the chain buffer for wear and ...