Inspect the hazard switch in the following procedures:
(Yellow)
If any abnormality is found, replace the left handlebar switch assembly with a new one. Refer to “handlebar removal and installation” in section 6b .
Special tool
: 09900–25008 (multi circuit tester
set)
Tester knob indication continuity ( )
Starter motor runs but does not crank the
engine
The starter motor runs when the transmission is in neutral, but does not run
when the transmission is in any position
other than neutral, with the side-stand up.
Step
Action
Yes
No
1
Check the side-stand switch. Refer to “side-stand / ignition
inte ...
General description
Combination meter system description
This combination meter mainly consists of a stepping motor, lcd (liquid
crystal display) and leds (light emitting
diode).
The tachometer pointer is driven by the stepping motor.
The lcds indicate followings:
speed, odo / trip 1 / trip 2 / fuel reserve ...
Specifications
Service data
Oil pump
Oil
Tightening torque specifications
Reference: for the tightening torque of fastener not specified in this
section, refer to “tightening torque list” in section 0c . ...