Suzuki GSX-R 1000 Service Manual: Headlight bulb and position light bulb replacement
| Caution when you touch the bulb with your bare hands, clean the bulb with a cloth moistened with alcohol or soap water to prevent premature bulb failure. |
Low beam bulb
- Remove the combination meter. Refer to “combination meter removal and installation” in section 9c .
- Disconnect the headlight (low beam) coupler (1).
- Remove the headlight bulb/socket (low beam) (2) by turning it counterclockwise.
- Replace the headlight bulb (low beam) with a new one.
- Reinstall the removed parts.
High beam bulb
- Remove the body cowling cover. Refer to “exterior parts removal and installation” in section 9d .
- Disconnect the headlight (high beam) coupler (1).
- Remove the headlight bulb/socket (high beam) (2) by turning it counterclockwise.
- Replace the headlight bulb (high beam) with a new one.
- Reinstall the removed parts.
Position light bulb
- Disconnect the position light socket (1).
- Replace the position light bulb (2) with a new one.
- Reinstall the position light socket.
Headlight removal and installation
Removal
Remove the body cowling assembly. Refer to “exterior parts removal and
installation” in section 9d .
Remove the air intake pipes (1). Refer to “exterior parts removal and
ins ...
Headlight beam adjustment
Adjust the headlight beam, both horizontally and
vertically.
Note
to adjust the headlight beam, adjust the
beam horizontally first, then vertically.
It is not necessar ...
Other materials:
Break-in
The first 800 km (500 miles) is the
most important in the life of your
motorcycle. Proper operation during
this break-in period will help
assure maximum life and performance
from your new motorcycle.
The following guidelines explain
proper break-in procedures.
Maximum engine speed recommen ...
DTC “c44” (p0130/p0135): ho2 sensor
(ho2s) circuit malfunction
Detected condition and possible cause
Detected condition
Possible cause
C44/P0130
Ho2 sensor output voltage is not input to
ecm during engine operation and running
condition.
Sensor voltage > 1.0 V
Ho2 sensor circuit is open or shorted to the po ...
Specifications
Specifications
Note
these specifications are subject to change without notice.
Dimensions and dry mass
Engine
Drive train
Chassis
Electrical
Capacities
...