Suzuki GSX-R 1000 Service Manual: Heated oxygen sensor (ho2s) removal and installation
Removal
 Do not
remove the ho2 sensor while it is hot. |
Caution
|
- Lift and support the fuel tank with the prop stay.
Refer to “fuel tank removal and installation” in section 1g .
- Disconnect the ho2 sensor coupler (1).
- Remove the ho2 sensor (2).
Installation
Install the ho2 sensor in the reverse order of removal.
Pay attention to the following points:
| Caution do not apply oil or other materials to the sensor air hole. |
- Tighten the ho2 sensor to the specified torque.
Tightening torque ho2 sensor (a): 25 n·m (2.5 Kgf-m, 18.0 Lbf-ft)
Heated oxygen sensor (ho2s) inspection
Refer to “dtc “c44” (p0130/p0135): ho2 sensor (ho2s) circuit malfunction” in section 1a (page 1a- 103).
Pair reed valve removal and installation
Removal
Lift and support the fuel tank with the prop stay.
Refer to “fuel tank removal and installation” in section 1g .
Remove the air cleaner box. Refer to “air cleaner box removal and ...
Other materials:
Front brake pad inspection
The extent of brake pads wear can be checked by observing the grooved limit
line “a” on the pads. When the wear exceeds the grooved limit line, replace the
pads with new ones. Refer to “front brake pad replacement” .
Caution
replace the brake pad as a set, otherwise
braking perform ...
Water hose inspection
Inspect the water hoses in the following procedures:
remove the side cowlings. Refer to “exterior parts
removal and installation” in section 9d (page 9d-
6).
Check the water hoses for crack, damage or engine
coolant leakage. If any defect is found, replace the
water hose wi ...
Iap sensor removal and installation
Removal
Lift and support the fuel tank. Refer to “fuel tank
removal and installation” in section 1g (page 1g-
9).
Disconnect the coupler (1) and vacuum hose (2).
Remove the iap sensor (3) from the air cleaner box.
Installation
Install the iap sensor in the reverse ord ...