Suzuki GSX-R 1000 Service Manual: Horn inspection
| Note if the horn sound condition is normal, it is not necessary to inspect the horn button continuity. |
Horn button inspection
- Remove the air cleaner box. Refer to “air cleaner box removal and installation” in section 1d .
- Disconnect the left handlebar switch lead wire coupler (1).
- Inspect the horn button for continuity with a tester.
If any abnormality is found, replace the left handlebar switch assembly with a new one.
Refer to “handlebar removal and installation” in section 6b .
Special tool
: 09900–25008 (multi circuit tester
set)
Tester knob indication
continuity (
)
Horn inspection
- Disconnect the horn coupler (1).
- Connect a 12 v battery to the horn terminals. If the sound is not heard from the horn, replace the horn with a new one.
- Connect the horn coupler
Ignition switch inspection
Inspect the ignition switch in the following procedures:
remove the air cleaner box. Refer to “air cleaner box removal and
installation” in section 1d .
Disconnect the ignition sw ...
Horn removal and installation
Removal
Disconnect the horn coupler (1).
Remove the horn (2) by removing the mounting
bolts.
Installation
Install the horn in the reverse order of removal. ...
Other materials:
Special situations require special care
Of course, there are some times
when full-force braking is not the
correct technique. When the road
surface is wet, loose, or rough,
you should brake with care. When
you're leaned over in a corner,
avoid braking. Straighten up
before braking. Better yet, slow
down before entering the corner. ...
Engine oil
Oil quality is a major contributor to
your engine's performance and
life. Always select good quality
engine oil. Suzuki recommends
the use of suzuki performance
4 motor oil or equivalent
engine oil. Use sf/sg or sh/
sj with jaso ma in api (american
petroleum institute) classification.
A ...
Fastener removal and installation
Type a
Removal
Depress the head of fastener center piece (1).
Pull out the fastener (2).
Installation
Let the center piece stick out toward the head so that
the pawls “a” closes.
Insert the fastener into the installation hole.
Note
to prevent the pawl ...