Suzuki GSX-R 1000 Service Manual: Iap sensor removal and installation
Removal
- Lift and support the fuel tank. Refer to “fuel tank removal and installation” in section 1g (page 1g- 9).
- Disconnect the coupler (1) and vacuum hose (2).
- Remove the iap sensor (3) from the air cleaner box.
Installation
Install the iap sensor in the reverse order of removal.
Iap sensor removal and installation
Refer to “dtc “c14” (p0120-h/l): tp sensor circuit malfunction” in section 1a .
Ckp sensor removal and installation
Removal
Remove the clutch cover. Refer to “clutch removal” in section 5c .
Remove the ckp sensor (1).
Installation
Install the ckp sensor in the reverse order of removal.
Refer ...
Tp sensor removal and installation
Refer to “throttle body disassembly and assembly” in section 1d .
Removal
Remove the throttle body. Refer to “throttle body
removal and installation” in section 1d (page 1d-
10).
Remo ...
Other materials:
DTC “c41” (p0230-h/l): fp relay circuit
malfunction
Detected condition and possible cause
Detected condition
Possible cause
C41
No voltage is applied to fuel pump.
Fuel pump relay circuit open or short.
Fuel pump relay malfunction.
Fuel pump relay switch circuit is shorted to power
source.
...
Ecm / various sensors
Since each component is a high-precision part, great
care should be taken not to apply any severe impacts
during removal and installation.
Be careful not to touch the electrical terminals of the
electronic parts (ecm, etc.). The static electricity from
your body may damage them. ...