Suzuki GSX-R 1000 Service Manual: Iat sensor inspection
Refer to “dtc “c21” (p0110-h/l): iat sensor circuit malfunction” in section 1a .
Inspect the iat sensor.
| Note iat sensor resistance measurement method is the same way as that of the ect sensor. Refer to “ect sensor inspection” (page 1c- 4). |
Caution
|
Iat sensor specification
Ap sensor inspection
Refer to “dtc “c22” (p1450-h/l): ap sensor circuit malfunction” in section 1a .
Iat sensor removal and installation
Removal
Remove the air cleaner box. Refer to “air cleaner box removal and
installation” in section 1d .
Remove the iat sensor (1) from the air cleaner box.
Installation
Install ...
Ap sensor removal and installation
Removal
Remove the front seat. Refer to “exterior parts
removal and installation” in section 9d (page 9d-
6).
Disconnect the starter relay (1) from the holder.
Disconnect the ...
Other materials:
Precautions
Precautions for exhaust system
To avoid
the risk of being burned, do not touch the exhaust system when the
system is hot. Any
service on the exhaust system should be performed when the system is
cool.
Caution
make sure that the exhaust pipes and muffler ...
Show data when trouble (displaying data at
the time of DTC)
Use of sds
Ecm stores the engine and driving conditions (in the form of data as shown in
the figure) at the moment of the
detection of a malfunction in its memory. This data is called “show data when
trouble”.
Therefore, it is possible to know engine and driving conditions (e.G., Whether
...
Continuity check
Measure resistance across coupler “b” (between “a”
and “c” in figure).
If no continuity is indicated (infinity or over limit), the
circuit is open between terminals “a” and “c”.
Disconnect the coupler “b” and measure resistance
between couplers “a” and “b-1”.
If no continuity ...