Suzuki GSX-R 1000 Service Manual: Iat sensor removal and installation
Removal
- Remove the air cleaner box. Refer to “air cleaner box removal and installation” in section 1d .
- Remove the iat sensor (1) from the air cleaner box.
Installation
Install the iat sensor in the reverse order of removal.
Pay attention to the following point:
- tighten the iat sensor screw (1) to the specified torque.
Tightening torque iat sensor mounting screw (a): 1.3 N·m (0.13 Kgfm, 1.0 Lbf-ft)
Ect sensor inspection
Refer to “dtc “c15” (p0115-h/l): ect sensor circuit malfunction” in section
1a .
Inspect the ect sensor in the following procedures:
remove the ect sensor. Refer to “ect sensor removal ...
Iat sensor inspection
Refer to “dtc “c21” (p0110-h/l): iat sensor circuit malfunction” in section
1a .
Inspect the iat sensor.
Note
iat sensor resistance measurement method
is the same way as that of the ...
Other materials:
Air valve removal and installation
Removal
Remove the wheel assembly. Refer to “front wheel assembly removal and
installation” and “rear wheel assembly removal and installation” .
Remove the tire. Refer to “tire removal and installation” .
Remove the air valve (1) from the wheel.
Installation
Install th ...
Lubrication points
Proper lubrication is important for
smooth operation and long life of
each working part of your motorcycle
and also for safe riding. It is
a good practice to lubricate the
motorcycle after a long rough ride
and after getting it wet it in the
rain or after washing it. Major
lubrication points ...
Voltage check
If voltage is supplied to the circuit being checked, voltage
check can be used as circuit check.
With all connectors/couplers connected and voltage
applied to the circuit being checked, measure
voltage between each terminal and body ground.
If measurements were taken as shown ...