Removal
The hot
engine can burn you. Wait until the engine is cool enough to touch. |
Caution disconnect the lead wire coupler before removing the ignition coil to avoid lead wire coupler damage. |
Caution
|
Special tool
(a): 09930–10121 (spark plug wrench
set)
Installation
Install the spark plugs in the reverse order of removal.
Pay attention to the following points:
Caution do not cross thread or over tighten the spark plug, or such an operation will damage the aluminum threads of the cylinder head. |
Special tool
(a): 09930–10121 (spark plug wrench
set)
Tightening torque spark plug: 11 n·m (1.1 Kgf-m, 8.0 Lbf-ft)
Caution do not hit the ignition coil with a plastic hammer when installing it. |
Spark plug inspection and cleaning
Refer to “spark plug inspection and cleaning” in section 0b .
Balancer shaft disassembly and assembly
Refer to “engine bottom side disassembly” (page 1d-
49).
Refer to “engine bottom side assembly” .
Disassembly
Remove the balancer shaft. Refer to “engine bottom side disassembly” .
Remove the washers, balancer gear and dampers
from the shaft.
Assembly
Assembly is in the re ...
Starting off
Warning
Riding this motorcycle at
excessive speed increases
your chances of losing control
of the motorcycle. This may
result in an accident.
Always ride within the limits of
your skills, your motorcycle,
and the riding conditions.
Warning
Remov ...
License plate light removal and installation
Removal
Remove the frame cover. Refer to “exterior parts
removal and installation” in section 9d (page 9d-
6).
Disconnect the license plate light coupler (1).
Remove the nuts.
Remove the license plate light assembly (2).
Installation
Install the license pl ...