Inspect the ignition switch in the following procedures:
If any abnormality is found, replace the ignition switch with a new one.
Special tool
: 09900–25008 (multi circuit tester
set)
Tester knob indication continuity ( )
E-02, 19, 24, 51
E-03, 14, 28, 33
Ignition switch removal and installation
Refer to “ignition switch removal and installation” in section 1h .
Special tools and equipment
Recommended service material
Note
required service material is also described in the following.
“Water hose routing diagram” “water pump components” “water
pump construction”
Special tool
...
Exhaust pipe bolt and muffler bolt inspection
Tighten exhaust pipe bolts and muffler bolts
initially at 1 000 km (600 miles, 2 months) and every
12 000 km (7 500 miles, 24 months) thereafter
Check the exhaust pipe bolts and muffler bolts to the
specified torque.
Tightening torque
exhaust pipe bolt (a): 23 n·m (2.3 Kgf-m, 16.5 Lbf-ft)
muf ...
Specifications
Specifications
Note
these specifications are subject to change without notice.
Dimensions and dry mass
Engine
Drive train
Chassis
Electrical
Capacities
...