Drive chain inspection and adjustment
Inspect drive chain
initially at 1 000 km (600 miles, 2 months) and every
6 000 km (4 000 miles, 12 months) thereafter
Drive chain visual check
With the transmission in neutral, support the
motorcycle using a jack and turn the rear wheel
slowly by hand.
Visually check the drive chain fo ...
Regulator / rectifier removal and installation
Removal
Turn the ignition switch off.
Remove the right side cowling. Refer to “exterior parts removal and
installation” in section 9d .
Lift and support the fuel tank. Refer to “fuel tank
removal and installation” in section 1g (page 1g-
9).
Remove the evap system purge ...
Engine coolant temperature indicator light inspection
Inspect the engine coolant temperature meter and indicator light (led) in the
following procedures:
remove the left side cowling. Refer to “exterior parts removal and
installation” in section 9d .
Disconnect the ect sensor coupler (1).
Connect a variable resistor (2) ...