When removing or replacing the isc valve, set the isc valve to the following procedures:
Note the leaned value of the isc valve is set at preset position. |
Note the isc valve opening initialization is automatically started after the ignition switch is turned off position. |
Ho2 sensor inspection
Refer to “dtc “c44” (p0130/p0135): ho2 sensor (ho2s) circuit malfunction” in section 1a (page 1a- 103).
Ho2 sensor removal and installation
Refer to “heated oxygen sensor (ho2s) removal and installation” in section 1b .
Gp switch inspection
Refer to “side-stand / ignition interlock system parts inspection” in section 1i .
Gp switch removal and installation
Refer to “gear position (gp) switch removal and installation” in section 5b .
Spark plug inspection and cleaning
Inspect spark plug
every 6 000 km (4 000 miles, 12 months)
Heat range
Remove the spark plugs. Refer to “ignition coil and spark plug removal
and installation” in section 1h .
Check spark plug heat range by observing electrode
color. If the electrode of the spark plug is wet
appe ...
Rear brake light switch inspection and adjustment
Check the rear brake light switch so that the brake light
will come on just before pressure is felt when the brake
pedal is depressed. If the brake light switch adjustment
is necessary, turn the adjuster nut (1) in or out while
holding the brake pedal.
Brake fluid level check
Refer to “bra ...
Rear shock absorber removal and installation
Removal
Remove the right side cowling and side frame covers. Refer to “exterior
parts removal and installation” in section 9d .
Support the motorcycle with a jack to relieve load on
the rear shock absorber.
Remove the left muffler and muffler chamber heat guard no. 2. Refer ...