Always ride within the boundaries of your own skills. Knowing these limits and staying within them will help you avoid accidents.
A major cause of accidents involving only a motorcycle (and no cars) is going too fast through a turn. Before entering a turn, select an appropriately low cornering speed.
Even on straight roads, ride at a speed that is appropriate for th~ traffic, visibility and road conditions, your motorcycle, and your experience.
Riding a motorcycle safely requires that your mental and physical skills are fully part of the experience. You should not attempt to operate a motor vehicle, especially one with two wheels, if you are tired or under the influence of alcohol or other drugs. Alcohol, illegal drugs, and even some prescription and overthe- counter drugs can cause drowsiness, loss of coordination, loss of balance, and especially the loss of good judgment. If you are tired or under the influence of alcohol or other drugs, please do not ride your motorcycle.
DTC “c13” (p0105-h/l): iap sensor circuit
malfunction
Detected condition and possible cause
Detected condition
Possible cause
C13
Iap sensor voltage is not within the
following range.
0.5 V ≤ Sensor voltage < 4.85 V
Note
note that atmospheric pressure
varies depending on weather
c ...
Side standngnition interlock switch
Check the side stand/ignition
interlock system for proper operation
as follows:
Sit on the motorcycle in the
normal riding position, with the
side stand up.
Shift into first gear, hold the
clutch in, and start the engine.
While continuing to hold the
clutch in ...
Throttle cable removal and installation
Removal
Remove the air cleaner box. Refer to “air cleaner box removal and
installation” .
Remove the right handlebar switch box. Refer to “handlebar removal and
installation” in section 6b .
Remove the throttle cables as shown in the cable routing diagram. Refer
to “thro ...