Clutch lever 1
The clutch lever is used for disengaging the drive to the rear wheel when starting the engine or shifting the transmission gear.
Squeezing the lever disengages the clutch.
Headlight flasher switch 2
Press the switch to light the headlight.
Dimmer switch 3
" " position
The headlight low beam and taillight turn on.
" " position
The headlight high beam and taillight turn on. The high beam indicator light also turns on.
Hazard warning switch 4
All four turn signal lights and indicators will flash simultaneously when the switch is turned on with the ignition switch in "on" or "p" position. Use the hazard warning lights to warn other traffic during emergency parking or when your vehicle could otherwise become a traffic hazard.
Turn signal light switch 5
Moving the switch to the ""
position will flash the left turn signals.
Moving the switch to the ""
position will flash the right turn
signals. The indicator light will
also flash intermittently. To cancel
turn signal operation, push the
switch in.
Warning
Other drivers may misjudge your course and this may result in an accident. Always use the turn signals when you intend to change lanes or make a turn. Be sure to turn off the turn signals after completing the turn or lane change. |
Horn switch "" 6
Press the switch to sound the horn.
Diagnostic information and procedures
Engine lubrication symptom diagnosis
Oil pressure check
Check the engine oil pressure periodically. This will give
a good indication of the condition of the moving parts.
Note
before checking the oil pressure, check the
following.
Oil level (refer to “engine oil and fi ...
Open circuit check
Possible causes for the open circuit are as follows. As
the cause can exist in the connector/coupler or terminal,
they need to be checked carefully.
Loose connection of connector/coupler.
Poor contact of terminal (due to dirt, corrosion or rust,
poor contact tension, entry of f ...
Washing the motorcycle
When washing the motorcycle,
follow the instructions below:
Remove dirt and mud from the
motorcycle with running water.
You may use a soft sponge or
brush. Do not use hard materials
which can scratch the
paint.
Wash the entire motorcycle
with a mild detergent or car
...