Suzuki GSX-R 1000 Service Manual: License plate light components

Rear combination light removal and installation

Removal Remove the frame cover assembly. Refer to “exterior parts removal and installation” in section 9d .  Remove the clamps (1).  Disconnect the combination light coupler (2). ...

License plate light removal and installation

Removal Remove the frame cover. Refer to “exterior parts removal and installation” in section 9d (page 9d- 6).  Disconnect the license plate light coupler (1). Remove the nuts ...

Other materials:

Fastener removal and installation
Type a Removal Depress the head of fastener center piece (1).  Pull out the fastener (2). Installation Let the center piece stick out toward the head so that the pawls “a” closes. Insert the fastener into the installation hole. Note to prevent the pawl ...

Rear brake components
Rear brake caliper Piston seal Dust seal Piston Rear caliper bracket Rear brake pad set Rear brake disc Brake pad spring 6 N·m (0.6 Kgf-m, 4.5 Lbf-ft) 27 N·m (2.7 Kgf-m, 19.5 Lbf-ft) 12 N·m (1.2 Kgf-m, 8.5 Lbf-ft) 17 N·m ...

Engine coolant
Coolant level The engine coolant solution should be between "f" (full) and "1..:' (Low) level lines on the engine coolant reservoir. If the level is lower than "1..:' (Low) level line, bring it up to "f" (full) level by adding 50:50 mixture of distilled water ...