Suzuki GSX-R 1000 Owners Manual: Most accidents can be avoided
The most common type of motorcycle accident in the u.S. Occurs when a car traveling towards a motorcycle turns left in front of the motorcycle. Is that because other drivers are out to get motorcyclists? No. Other drivers simply don't always notice motorcyclists.
Ride defensively. Wise motorcyclists use a strategy of assuming they are invisible to other drivers, even in broad daylight. Pay careful attention to other motorists, especially at intersections, because they may not be paying attention to you. Select a lane position that gives you the best view of others, and other motorists the best view of you. Wear bright, reflective clothing. Put reflective strips on your helmet.
The sport of motorcycling
Your motorcycle and this owner's
manual have been designed by
people like you who enjoy motorcycling.
People become motorcyclists
for many reasons. For
starters, street riding is fun and
invig ...
If you don't have a helmet, buy a helmet and wear it every
time you ride
Most accidents occur within a few
miles of home, and almost half
occur at speeds of less than 30
mph. So even if you're just going
on a quick errand, be preparedstrap
on your helmet before you
t ...
Other materials:
DTC “c62” (p0443): evap system purge
control solenoid valve circuit malfunction
(e-33 only)
Detected condition and possible cause
Detected condition
Possible cause
Evap system purge control valve voltage is not input to
ecm.
Evap system purge control valve circuit open or short.
Evap system purge control valve malfunction.
Ecm malfunction. ...
Precautions
Precautions for brake system
Refer to “general precautions” in section 00 (page 00-1).
Brake fluid information
This brake system is filled with an ethylene glycol-based dot 4
brake fluid. Do not use or mix
different types of fluid, such as silicone-based or petroleum-based.
...
Using the testers
Incorrectly connecting the (+) and (.) Probes may
cause the inside of the tester to be burned.
If the voltage and current are not known, make
measurements using the highest range.
When measuring the resistance with the multi-circuit
tester (1), ∞ will be shown as 10.00 ...