Removal
Note support the muffler to prevent it from falling. |
Refer to “fuel tank removal and installation” in section 1g .
(Rh only)
Caution
|
Caution take care not to bend the radiator/oil cooler fins. |
Note support the exhaust pipe assembly to prevent it from falling. |
Installation
Installation is in the reverse order of removal. Pay attention to the following points:
Tightening torque ho2 sensor (a): 25 n·m (2.5 Kgf-m, 18.0 Lbf-ft)
Caution
|
Caution replace the gaskets and connectors with new ones. |
Note when installing a new connector, remove all of the old sealer. Apply the exhaust gas sealer to both the inside and outside of the new connector. |
: Muffler seal (muffler
seal loctite
5920 (commercially available) or equivalent)
Specifications
Service data
Brake
unit: mm (in)
Tightening torque specifications
Note
the specified tightening torque is described in the following.
“Front brake hose routing diagram” “rear brake hose routing
diagram” “front brake master cylinder components” “rear
...
License plate light removal and installation
Removal
Remove the frame cover. Refer to “exterior parts
removal and installation” in section 9d (page 9d-
6).
Disconnect the license plate light coupler (1).
Remove the nuts.
Remove the license plate light assembly (2).
Installation
Install the license pl ...
Oil cooler / oil cooler hose inspection and
cleaning
Refer to “exterior parts removal and installation” in section 9d .
Oil cooler hose inspection
Inspect the oil cooler hoses for any damage and oil
leakage. If any defects are found, replace the oil cooler
hose with a new one.
Oil cooler inspection
Remove the oil cooler guard (1).
...