Troubleshooting
Note check that the transmission is in neutral and the engine stop switch is in the “run” position. Grasp the clutch lever. Check that the fuse is not blown and the battery is fully-charged before diagnosing. |
Regulated voltage inspection
Inspect the regulated voltage in the following
procedures:
remove the front seat. Refer to “exterior parts
removal and installation” in section 9d (page 9d-
6).
Start the engine and keep it running at 5 000 r/min
with the dimmer switch turned hi position.
Measure the dc vo ...
Specifications
Tightening torque specifications
Note
the specified tightening torque is described in the following.
“Handlebar components” “steering components” “steering
damper construction”
Reference: for the tightening torque of fastener not specified in this
section ...
DTC “c13” (p0105-h/l): iap sensor circuit
malfunction
Detected condition and possible cause
Detected condition
Possible cause
C13
Iap sensor voltage is not within the
following range.
0.5 V ≤ Sensor voltage < 4.85 V
Note
note that atmospheric pressure
varies depending on weather
c ...