Inspect the oil pressure indicator in the following procedures:
Note before inspecting the oil pressure switch, check if the engine oil level is correct. Refer to “engine oil and filter replacement” in section 0b . |
If the oil pressure indicator does not light up, replace the combination meter assembly with a new one after checking the connection of couplers.
Oil pressure switch removal and installation
Refer to “oil pressure switch removal and installation” in section 1e .
Stopping and parking
Twist the throttle grip away
from yourself to close the
throttle completely.
Apply the front and rear brakes
evenly and at the same time.
Downshift through the gears
as road speed decreases.
Select neutral with the clutch
lever squeezed toward the grip
(disenga ...
Procedure for returning
to service
Clean the entire motorcycle.
Remove the oily rags from the
air cleaner intake and muffler
outlet.
Drain all the engine oil. Install
a new oil filter and fill the
engine with fresh oil as outlined
in this manual.
Remove the spark plugs. Turn
the engine a few tim ...
Engine coolant temperature indicator light inspection
Inspect the engine coolant temperature meter and indicator light (led) in the
following procedures:
remove the left side cowling. Refer to “exterior parts removal and
installation” in section 9d .
Disconnect the ect sensor coupler (1).
Connect a variable resistor (2) ...