Suzuki GSX-R 1000 Service Manual: Oil pressure switch inspection
Inspect the oil pressure switch in the following procedures:
| Note before inspecting the oil pressure switch, check if the engine oil level is correct. Refer to “engine oil and filter replacement” in section 0b . |
- Remove the left side cowling. Refer to “exterior parts removal and installation” in section 9d .
- Disconnect the oil pressure switch lead wire from the oil pressure switch.
- Inspect the oil pressure switch for continuity with the tester. If any abnormality is found, replace the oil pressure switch with a new one.
Special tool
: 09900–25008 (multi circuit tester
set)
Tester knob indication
continuity ( 
)
- After finishing the oil pressure switch inspection, reinstall the removed parts.
Oil pressure indicator inspection
Inspect the oil pressure indicator in the following
procedures:
Note
before inspecting the oil pressure switch, check if the engine oil level
is correct. Refer to “engine oil and filte ...
Ignition switch inspection
Inspect the ignition switch in the following procedures:
remove the air cleaner box. Refer to “air cleaner box removal and
installation” in section 1d .
Disconnect the ignition sw ...
Other materials:
Rear brake light switch inspection
Inspect the rear brake light switch in the following
procedures:
lift and support the fuel tank. Refer to “fuel tank
removal and installation” in section 1g (page 1g-
9).
Disconnect the rear brake light switch lead wire
coupler (1).
Inspect the rear brake light swi ...
DTC “c23” (p1651-h/l): to sensor circuit
malfunction
Detected condition and possible cause
Detected condition
Possible cause
C23
The sensor voltage should be the
following for 2 sec. And more, after ignition
switch is turned on.
0.2 V ≤ Sensor voltage < 4.8 V
To sensor circuit open or shor ...
Ckp sensor removal and installation
Removal
Remove the clutch cover. Refer to “clutch removal” in section 5c .
Remove the ckp sensor (1).
Installation
Install the ckp sensor in the reverse order of removal.
Refer to “clutch installation” in section 5c .
Iap sensor inspection
Refer to “dtc “c13” (p0105-h/l): ia ...