Note be careful not to drop any parts into the crankcase. |
Removal
Installation
Caution use a new o-ring to prevent oil leakage. |
: Grease 99000–25010 (suzuki
super
grease “a” or equivalent)
Note engage the oil pump shaft end with the water pump shaft slot. |
Tightening torque oil pump mounting bolt (a): 10 n·m (1.0 Kgf-m, 7.0 Lbf-ft)
: Thread lock cement
99000–32110
(thread lock cement super “1322” or
equivalent)
Tightening torque oil pump driven sprocket bolt (b): 10 n·m (1.0 Kgf-m, 7.0 Lbf-ft)
Pair system inspection
Inspect pair system
every 12 000 km (7 500 miles, 24 months)
Inspect the pair (air supply) system periodically. Refer to “pair system
inspection” in section 1b .
Throttle valve synchronization
Inspect throttle valve synchronization
initially at 1 000 km (600 miles, 2 months) (e-33 only)
and ...
Front brake master cylinder components
Reservoir cap
Plate
Diaphragm
Reservoir tank
Master cylinder
Dust boot
Piston set
Brake lever
Brake lever pivot bolt
Brake lever pivot bolt lock-nut
Brake light switch
Brake hose union bolt
Brake hose
23 N·m (2.3 Kgf-m,
...
Engine oil level check
Check the engine oil level as follows:
Place the motorcycle on level
ground on the side stand.
Start the engine and allow it to
idle for a few minutes.
Stop the engine and wait three
minutes.
Hold the motorcycle vertically
and check the oil level through
...