When handling the electrical parts or servicing fi system, observe the following points for the safety of the systems.
Gearshift linkage inspection
Refer to “gearshift shaft / gearshift cam plate removal and installation” .
Gearshift shaft
Check the gearshift shaft for bend or wear.
Check the return spring for damage or fatigue.
If any defects are found, replace the defective part(-s).
Gearshift shaft oil seal
Inspect the gearshif ...
Speed sensor removal and installation
Removal
Remove the left side cowling. Refer to “exterior parts removal and
installation” in section 9d .
Disconnect the speed sensor lead wire coupler (1).
Remove the speed sensor (2).
Installation
Install the speed sensor in the reverse order of removal.
Pay atte ...
Ect sensor inspection
Refer to “dtc “c15” (p0115-h/l): ect sensor circuit malfunction” in section
1a .
Inspect the ect sensor in the following procedures:
remove the ect sensor. Refer to “ect sensor removal and installation” .
Connect the ect sensor (1) to the circuit tester and
place it in the o ...