Inspect the radiator cap in the following procedures:
If the radiator cap does not hold the pressure for at least 10 seconds, replace it with a new one.
Radiator cap release pressure 93 – 123 kpa (0.9 – 1.2 Kgf/cm2, 13.2 – 17.5 Psi)
Radiator reservoir tank inspection
Inspect the radiator reservoir tank in the following
procedures:
remove the right side cowling. Refer to “exterior parts removal and
installation” in section 9d .
Inspect the radiator reservoir tank (1) for leaks. If any
defects are found, replace the radiator reservoir tank
...
Rear brake master cylinder parts inspection
Refer to “rear brake master cylinder disassembly and assembly” .
Master cylinder
Inspect the master cylinder bore for any scratches or
other damage.
Piston / rubber parts
Inspect the piston surface for any scratches or other
damage.
Inspect the primary cup, secondary cup and dust boot
...
Instrument panel
The fuel indicator light 8,12,13
Lcd's and tachometer needle
work as follows to confirm their
function when the ignition switch
is turned to the "on" position.
The fuel indicator light 8,12
and 13 come on for 3 seconds.
All lcd segments display for 3
seconds.
&nbs ...