Suzuki GSX-R 1000 Service Manual: Radiator / cooling fan motor removal and
installation
Removal
- Remove the inner under cowlings. Refer to “exterior parts removal and
installation” in section 9d .
- Drain engine coolant. Refer to “cooling system inspection” in section
0b .
- Disconnect the reservoir tank inlet hose (1) and
water air bleed hose (2).
- Remove the radiator reservoir tank (3).
- Disconnect the radiator inlet hose (4).
- Disconnect the cooling fan motor coupler (5).
- Remove the oil cooler (6) from the bracket.
- Remove the radiator assembly by removing the
bolts.
- Remove the radiator outlet hose (7) and cooling fan
motor (8) from the radiator.
Installation
Install the radiator in the reverse order of removal. Pay
attention to the following points:
- install the radiator and oil cooler to their bracket. Refer to
“radiator inspection and cleaning” .
- Apply thread lock to the reservoir tank bolt and tighten
it securely.
: Thread lock cement
99000–32110
(thread lock cement super “1322” or
equivalent)
- Connect the radiator hoses securely. Refer to “water hose routing
diagram” .
- Pour engine coolant. Refer to “cooling system inspection” in section 0b
.
- Bleed air from the cooling circuit. Refer to “cooling system
inspection” in section 0b .
Radiator hose inspection
Refer to “cooling system inspection” in section 0b .
Radiator inspection
Inspect the radiator for water leaks. If any defects are
found, replace the radiator with a new on ...
Inspect the water hoses in the following procedures:
remove the side cowlings. Refer to “exterior parts
removal and installation” in section 9d (page 9d-
6).
Check the water hose ...
Other materials:
Special tools and equipment
Recommended service material
Note
required service material is also described in the following.
“Clutch control system components” “clutch components”
Special tool
...
Front brake hose removal and installation
Removal
Drain brake fluid. Refer to “brake fluid replacement” .
2) Remove the front brake hoses as shown in the front brake hose routing
diagram. Refer to “front brake hose routing diagram” .
Installation
Caution
the seal washers should be replaced with the
new ones to pr ...
Special tools and equipment
Recommended service material
Note
required service material is also described in the following.
“Handlebar components” “steering components” “steering
damper construction”
Special tool
...