Suzuki GSX-R 1000 Service Manual: Radiator reservoir tank inspection
Inspect the radiator reservoir tank in the following procedures:
- remove the right side cowling. Refer to “exterior parts removal and installation” in section 9d .
- Inspect the radiator reservoir tank (1) for leaks. If any defects are found, replace the radiator reservoir tank with a new one.
- Reinstall the removed parts.
Water hose removal and installation
Removal
Remove the side cowlings. Refer to “exterior parts
removal and installation” in section 9d (page 9d-
6).
Drain engine coolant. Refer to “cooling system inspection” in section
...
Radiator reservoir tank removal and
installation
Removal
Remove the right side cowling. Refer to “exterior parts removal and
installation” in section 9d .
Disconnect the reservoir tank inlet hose (1) from the
reservoir tank (2) and ...
Other materials:
Throttle body construction
Intake pipe
Evap system purge control solenoid valve
(e-33 only)
Evap canister (e-33 only)
Iat sensor
Isc valve hose
Ho2 sensor
Face
the clamp end left side.
Yellow
marking should face upward.
Face the
end of clamps upward and ke ...
Fuel tank cap
To open the fuel tank cap, insert
the ignition key into the lock and
turn it clockwise. With the key
inserted, lift up with the key and
open the fuel tank cap. To close
the fuel tank cap, push the cap
down firmly with the key in the cap
lock.
Fuel level
Fi ller neck
Wa ...
Cooling circuit inspection
Do not open the radiator cap when the
engine is hot, as you may be injured by
escaping hot liquid or vapor.
When removing the radiator cap tester, put
a rag on the filler to prevent the engine
coolant from spraying out.
Inspect the cooling ...