Removal
Installation
Regulated voltage inspection
Inspect the regulated voltage in the following
procedures:
remove the front seat. Refer to “exterior parts
removal and installation” in section 9d (page 9d-
6).
Start the engine and keep it running at 5 000 r/min
with the dimmer switch turned hi position.
Measure the dc vo ...
Exhaust control valve inspection
Inspect exhaust control valve
initially at 1 000 km (600 miles, 2 months) and every
12 000 km (7 500 miles, 24 months) thereafter
Inspect exhaust control valve as follows:
remove the left side cowling. Refer to “exterior parts removal and
installation” in section 9d .
Check t ...
Accessory installation
guideline
Install aerodynamic affecting
accessories, such as a fairing,
windshield, backrests, saddlebags,
and travel trunks, as low
as possible, as close to the
motorcycle and as near the
center of gravity as is feasible.
Check that the mounting
brackets and other attachment
hardware are ...