Brake disc thickness
Check the brake disc for damage or cracks and measure the thickness using the micrometer.
Replace the brake disc if the thickness is less than the service limit or if defect is found.
Special tool
(a): 09900–20205 (micrometer (0 –
25 mm))
Brake disc thickness service limit (rear): 4.5 Mm (0.18 In)
Brake disc runout
Replace the disc if the runout exceeds the service limit.
Special tool
(a): 09900–20607 (dial gauge)
: 09900–20701 (dial gauge chuck)
Brake disc runout service limit: 0.30 Mm (0.012 In)
Fuel line inspection
Inspect fuel line
every 6 000 km (4 000 miles, 12 months)
Inspect the fuel line in the following procedures:
lift and support the fuel tank. Refer to “fuel tank
removal and installation” in section 1g (page 1g-
9).
Inspect the fuel feed hose (1) for damage and fuel
leakage. ...
Transmission components
2Nd drive gear
6Th drive gear
3Rd/4th drive gear
5Th drive gear
Countershaft/1st drive gear
Driveshaft
2Nd driven gear
6Th driven gear
3Rd driven gear
4Th driven gear
5Th driven gear
1St driven gear
Gearshift cam stopper
Gearshi ...
Rear shock absorber inspection
Refer to “rear shock absorber removal and installation” .
Shock absorber
Inspect the rear shock absorber for damage and oil
leakage, and absorber bushing for wear and damage. If
any defect is found, replace the rear shock absorber with
a new one.
Caution
do not attempt to disassemble ...