Suzuki GSX-R 1000 Service Manual: Rear brake disc removal and installation

Rear brake caliper parts inspection

Refer to “rear brake caliper disassembly and assembly” . Brake caliper cylinder Inspect the brake caliper cylinder wall for nicks, scratches or other damage. If any damage is found, replace the ca ...

Rear brake disc inspection

Brake disc thickness Check the brake disc for damage or cracks and measure the thickness using the micrometer. Replace the brake disc if the thickness is less than the service limit or if defect ...

Other materials:

Front brake disc removal and installation
Removal Remove the front wheel assembly. Refer to “front wheel assembly removal and installation” in section 2d .  Remove the front brake disc. Installation Install the front brake disc in the reverse order of removal. Pay attention to the following points:  make sure ...

Regulated voltage inspection
Inspect the regulated voltage in the following procedures:  remove the front seat. Refer to “exterior parts removal and installation” in section 9d (page 9d- 6).  Start the engine and keep it running at 5 000 r/min with the dimmer switch turned hi position. Measure the dc vo ...

Fi system troubleshooting
Customer complaint analysis Record details of the problem (failure, complaint) and how it occurred as described by the customer. For this purpose, use of such an inspection form such as following will facilitate collecting information to the point required for proper analysis and diagnosis. ...