Suzuki GSX-R 1000 Service Manual: Rear brake hose removal and installation
Removal
- Drain brake fluid. Refer to “brake fluid replacement” .
- Remove the rear brake hoses as shown in the rear brake hose routing diagram. Refer to “rear brake hose routing diagram” .
Installation
| Caution the seal washers should be replaced with new ones to prevent fluid leakage. |
- Install the rear brake hose as shown in the rear brake hose routing diagram. Refer to “rear brake hose routing diagram” .
- Bleed air from the rear brake system. Refer to “air bleeding from brake fluid circuit” .
Front brake hose removal and installation
Removal
Drain brake fluid. Refer to “brake fluid replacement” .
2) Remove the front brake hoses as shown in the front brake hose routing
diagram. Refer to “front brake hose routing diagram” ...
Front brake master cylinder components
Reservoir cap
Plate
Diaphragm
Reservoir tank
Master cylinder
Dust boot
Piston set
Brake lever
Brake lever pivot bolt
Brake lever pivot bolt lock ...
Other materials:
Battery current leakage inspection
Inspect the battery current leakage in the following
procedures:
turn the ignition switch off.
Remove the front seat. Refer to “exterior parts
removal and installation” in section 9d (page 9d-
6).
Disconnect the battery (–) lead wire.
Measure the current betwee ...
Voltage check
If voltage is supplied to the circuit being checked, voltage
check can be used as circuit check.
With all connectors/couplers connected and voltage
applied to the circuit being checked, measure
voltage between each terminal and body ground.
If measurements were taken as shown ...
Front brake disc inspection
Brake disc thickness
Check the brake disc for damage or cracks and measure
the thickness using the micrometer.
Replace the brake disc if the thickness is less than the
service limit or if defect is found.
Special tool
(a): 09900–20205 (micrometer (0 –
25 mm))
Brake disc thickness
service ...